Hinkley Lighting CASA 4018OL - Manual

assembly instructions
Family: Casa Item No. 4018 OL
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
*** The construction of this fixture will be accomplished by first assembling the main
body of the fixture, installing the mounting hardware, making all necessary electrical
connections, hanging the fixture from the ceiling and then installing the glass.
start here
4018
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Drawing 1 - Arm Spread
10.3.08
Drawing 2 - Fixture Assembly
1. Rotate the six lower arms (A) of the main body assembly (1) until they are equally
spaced 60 degrees apart - See Drawing 1.
2. Rotate the top three arms (B) until they are equally spaced 120 degress apart and
also equally spaced between two of the lower arms (A).
3. Slip center stem (2) along wire and thread into coupler (C), located on top of the
main body (1), and tighten.
4. Take center column assembly (3) and rotate arms untill they are equally spaced 120
degress apart. Then slip assembly along wire and slide over center stem (2). Making
sure the bottom scorlls ends (D) fit over the square pegs (E) located on the top of the
main body assembly (1), and also making sure scroll work on center column is aligned
with the arms (A) on main body and equally spaced between the arms (B).
5. Slip top cap (4) along wire and over center stem (2).
6. Silp washer (5) along wire and over center stem (2).
7. Slip spacer (6) along wire and over center stem (2).
8. Slip loop (7) along wire and thread onto end of center stem (2) and tighten to
secure center column assembly.
9. Fixture can now be installed. Please follow instruction sheet IS-19 provided. After
installation return to this section for Glass installation instructions.
1. To install glass first remove socket ring (8) from socket (F).
2. Slip glass (9) over socket.
3. Thread socket ring (8) back onto socket (F) and tighten to secure glass.
4. Fixture can be lamped accordingly at this time.
5. Fixture is complete.
60º
A
120º
A
A
A
A
A
B
B
B
2
3
4
5 6
7
9
8
F
A
E
D
B
1
C
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com