Hinkley Lighting OMNI 57202PN - Manual

H I N K L E Y L I G H T I N G 33000Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 44.653.5500 hinkleylighting.com
assembly instructions
Item No. 57202
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
1. Prepare mounting strap (A) by threading 1-5/8” nipple into the center hole of the
mounting strap (A), approximately 1/4“.- see Drawing 1.
2. Attach mounting strap (A) to junction box (J) using two screws (B) provided.
1. To mount fixture, slip center hole of backplate (E) over threaded tube (C)
and hold fixture in position - see Drawing 1 .
2. Thread decorative knob (D) onto end of nipple (C) and tighten to secure fixture.
*** The construction of this fixture will be accomplished by first attaching the
mounting strap to the junction box, making all necessary electrical connections,
mounting the fixture to the wall, and then installing the glass.
start here
57202
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Drawing 1 - Fixture Mounting
Drawing 2 - Glass Installation
Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.
Then refer back to this sheet to continue installation of this fixture.
5
A J
B
C D
E
01.01.13
install
lamp
before
installing
glass
3
2
1
4
Note: Fixture should be lamped accordingly at this point before installing
the glass.
1. To install glass, slip glass (4) over socket (3).
2. Slip spacer (2) over socket (3) inside the glass (4).
3. Thread bulb shield (1) onto socket (3) and tighten by hand until snug against
spacer (2) to secure glass. Do not over tighten.