Watts 144 User Manual

Watts no. 142, Process boiler water feeder, With direct feed through float chamber)

Advertising
background image

IS-142

Watts No. 142

Process Boiler Water Feeder

(With Direct Feed Through Float Chamber)

Without Strainer- - - - - - - - - - - Type 142

With Strainer- - - - - - - - - - - - - Type 142S

“ATTENTION INSTALLER: After installation, please leave this
Instruction Sheet for occupant’s information.”

For use on pressing machines and other small process boil-
ers when feed through fl oat chamber is permissible.

Water is fed automatically as needed to maintain the correct
operating level in the boiler.

The entire unit is simple in design and operation, easy to
install and inexpensive to operator.

The simple construction of the feed valve permits quick and
easy cleaning should it become fouled by dirt in the water
supply.

Diff. between steam

Boiler Horse Power

and water pressure.

10

8

20

13

30

16

40

18

50

19

Capacity

Specifi cations

Connections:

Water Feed - 1⁄2" (13mm)
N.P.T. Female

Float Chamber - 1" (25mm)

N.P.T.

Female

Pressure:

Steam - Max. 100 psi (6.9 bars)

Water - Max. 125 psi (8.6 bars)

Water Pressure must be at least

10 psi (69 kPa) higher than steam

pressure.

Installation Instructions

Install feeder as illustrated. If boiler tappings for equalizing pipes
“A” and “B” are not available, connect either one or both as
shown by dotted lines. Install with “water line” mark on fl oat
chamber on a level with the middle try-cock, or about halfway
up the gauge glass. Connect water supply line “C”. If a strainer
is used, install it in this line.

Install by-pass “D” so that boiler can be fi lled by hand, if neces-
sary.

All valves should be tight-closing and of good quality. Leaky
valves will fl ood boiler. Blow down fl oat chamber at least once
a week by opening valve “F” and letting water run for a few
minutes.

A shutoff and check valve must be installed in the water supply
line “E”.

Dotted lines indicate
method of installing
when tappings in boiler
shown in illustration are
not available

Check Valve Shut-Off

Watts type 142

Boiler

union

F

A

B

C

D

E

8

7

8

" (225mm)

6"

(152mm)

1

3

8

"

(35mm)

2

3

8

"

(60mm)

4

7

8

"

(124mm)

2

1

2

"

(64mm)

1" N.P.T.

1" N.P.T.

1

2

" N.P.T.

Limited Warranty: Watts Regulator Co. (the “Company”) warrants each product to be free from defects in material
and workmanship under normal usage for a period of one year from the date of original shipment. In the event of such
defects within the warranty period, the Company will, at its option, replace or recondition the product without charge.
THE WARRANTY SET FORTH HEREIN IS GIVEN EXPRESSLY AND IS THE ONLY WARRANTY GIVEN BY THE COMPANY
WITH RESPECT TO THE PRODUCT. THE COMPANY MAKES NO OTHER WARRANTIES, EXPRESS OR IMPLIED. THE
COMPANY HEREBY SPECIFICALLY DISCLAIMS ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING
BUT NOT LIMITED TO THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR
PURPOSE.
The remedy described in the first paragraph of this warranty shall constitute the sole and exclusive remedy for breach
of warranty, and the Company shall not be responsible for any incidental, special or consequential damages, including
without limitation, lost profits or the cost of repairing or replacing other property which is damaged if this product does
not work properly, other costs resulting from labor charges, delays, vandalism, negligence, fouling caused by foreign
material, damage from adverse water conditions, chemical, or any other circumstances over which the Company has
no control. This warranty shall be invalidated by any abuse, misuse, misapplication, improper installation or improper
maintenance or alteration of the product.
Some States do not allow limitations on how long an implied warranty lasts, and some States do not allow the exclu-
sion or limitation of incidental or consequential damages. Therefore the above limitations may not apply to you. This
Limited Warranty gives you specific legal rights, and you may have other rights that vary from State to State. You
should consult applicable state laws to determine your rights. SO FAR AS IS CONSISTENT WITH APPLICABLE STATE
LAW, ANY IMPLIED WARRANTIES THAT MAY NOT BE DISCLAIMED, INCLUDING THE IMPLIED WARRANTIES OF
MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED IN DURATION TO ONE YEAR FROM
THE DATE OF ORIGINAL SHIPMENT.

IS-142.indd 1

9/16/08 7:26:55 AM

Advertising
This manual is related to the following products:

142