Watts WFTC User Manual

Series wftc f&t cover assembly repair kit, Installation instructions

Advertising
background image

1. Close supply and return side valves and let steam trap cool.
2. Remove bolts (A) wire brush clean if needed, and put aside.
3. Remove existing cover assembly and discard. Remove old cover gasket and

discard. Make sure that the body fl ange is clean and all remnants of the old
gasket are scraped off. Trap body (D) stays attached to the system piping.
Clean out any sludge/debris from inside the trap body.

4. Install new cover assembly (B) with new cover gasket (C), making sure port

(E) lines up with similar port in the gasket and trap body. Reinstall original
bolts and torque between 25-40 ft - lbs.

5. Slowly open supply valve, then slowly open return side valve. Check and

retorque bolts after the trap is at operating temperature.

IS-WFTC 0829

EDP# 1910796

© Watts, 2008

USA: 815 Chestnut St., No. Andover, MA 01845-6098; www.watts.com

Canada: 5435 North Service Rd., Burlington, ONT. L7L 5H7; www.wattscanada.ca

W a t e r S a f e t y & F l o w C o n t r o l P r o d u c t s

Limited Warranty: Watts Regulator Co. (the “Company”) warrants each product to be free from defects in material and workmanship under normal usage for a period of one year from the date of
original shipment. In the event of such defects within the warranty period, the Company will, at its option, replace or recondition the product without charge.
THE WARRANTY SET FORTH HEREIN IS GIVEN EXPRESSLY AND IS THE ONLY WARRANTY GIVEN BY THE COMPANY WITH RESPECT TO THE PRODUCT. THE COMPANY MAKES NO OTHER
WARRANTIES, EXPRESS OR IMPLIED. THE COMPANY HEREBY SPECIFICALLY DISCLAIMS ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO THE IMPLIED
WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.
The remedy described in the first paragraph of this warranty shall constitute the sole and exclusive remedy for breach of warranty, and the Company shall not be responsible for any incidental, special
or consequential damages, including without limitation, lost profits or the cost of repairing or replacing other property which is damaged if this product does not work properly, other costs resulting
from labor charges, delays, vandalism, negligence, fouling caused by foreign material, damage from adverse water conditions, chemical, or any other circumstances over which the Company has no
control. This warranty shall be invalidated by any abuse, misuse, misapplication, improper installation or improper maintenance or alteration of the product.
Some States do not allow limitations on how long an implied warranty lasts, and some States do not allow the exclusion or limitation of incidental or consequential damages. Therefore the above
limitations may not apply to you. This Limited Warranty gives you specific legal rights, and you may have other rights that vary from State to State. You should consult applicable state laws to
determine your rights. SO FAR AS IS CONSISTENT WITH APPLICABLE STATE LAW, ANY IMPLIED WARRANTIES THAT MAY NOT BE DISCLAIMED, INCLUDING THE IMPLIED WARRANTIES OF
MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED IN DURATION TO ONE YEAR FROM THE DATE OF ORIGINAL SHIPMENT.

Series WFTC F&T Cover Assembly
Repair Kit

Installation Instructions

IS-WFTC

Installation

SMALL VALVE REASSEMBLY

IS-WFTC.indd 1

9/12/08 12:51:44 PM

Advertising