E-flite Apprentice 15e PNP - Manual (Page 14)

14 E-flite Apprentice PNP Assembly Manual
ChECKING ThE ELEvATOR (MODE 1)
 3. Center the elevator stick. This is the left stick
on the transmitter. The elevator should not be
deflected up or down, but should be flat with the
horizontal stabilizer when viewed from the side. If
the elevator is deflected up or down you will need
to push the silicone keeper back off the clevis,
onto the pushrod. This will enable you to open
the clevis up and remove it from the control horn.
Once removed, screw the clevis in or out to get the
elevator to line up with the stab.
Centered
Up—Thread clevis out
Down—Thread clevis in
 4. Check the movement of the elevator with the
radio system. Pulling the elevator/rudder stick (left
stick on the Mode 1 transmitter) back will make the
airplane elevator move up.
 5. Check the movement of the elevator with the
radio system. Pushing the elevator/rudder stick
forward will make the airplane elevator move
down on the Mode 1 transmitter.