E-flite Beechcraft Bonanza 15e ARF - Manual (Page 13)

13 Beechcraft Bonanza 15e ARF Assembly Manual
□
Step 12
Repeat steps 6 through 11 to locate and install the
elevator servo in the right side of the fuselage.
□□
Step 13
Measure 14 inches from the threaded end of the
ruddervator pushrods and form a 90-degree
bend using pliers.
□□
Step 14
Use sidecutters to trim the bent end of the pushrod
to a length of 1/4-inch.
□□
Step 15
Insert the ruddervator pushrods into the
upper guide tubes by feeding them through the
openings in the top of the firewall.
□□
Step 16
Use your radio to center the ruddervator
servos. Insert the pushrods into the outer hole of the
servo arms and secure them with snap keepers.
□□
Step 17
Slide a silicone keeper on to the threaded end of
each pushrod. Install a clevis on each of the pushrod
ends so that it is approximately centered on the
threads.