E-flite Brio 10 ARF - Manual (Page 49)

Final Assembly
Required Parts
• Fuselage
• Receiver
• 3-cell 11.1V Li-Po, 16GA
• Hook and loop tape (2)
• Canopy hatch
Required Tools and Adhesives
• Thin CA
Optional Parts
• Hook and loop strap
 1. Check to make sure all servo wires and ESC
wires can reach the location of the receiver before
mounting the receiver. Cut a piece of the hook
and loop tape to the size of the receiver. Install
the receiver using the hook and loop. Plug in
the rudder, elevator, and aileron servos (after
attaching the wing). Route the receiver antenna to
the rear of the plane.
Note: Do not cut the receiver antenna, as
this will greatly reduce the range of the radio
system.
Hint: Position the receiver so the ailerons can be
plugged in easily.
49