E-flite Ultimate 3D Profile ARF - Manual (Page 16)

17
❍ 5. Attach a control horn onto the rudder
using a control horn backplate. Add a
few drops of foam safe CA to the horn to
secure it in place.
❍ 6. Attach the L-bend to the control horn using
a micro pushrod keeper. (The control horn is
not on control surface for more detail.)
❍ 7. Roughen 4–6 pushrod guides, using medium
grit sandpaper. Slide the pushrod guides onto
the pushrod wire. Pass the wire through the
micro control connectors.
16
❍ 2. Use your radio system to electronically
center two servos for use on the rudder and
elevator. It is highly suggested to install long
servo arms at this time. Center the output of
the servo in the slots and use double-sided
tape to attach the servos to the fuselage.
❍ 3. Install the micro control connectors onto the
rudder servo arm. The screw will face away
from the wing for later adjustments.
❍ 4. Make an L-bend in one of the pushrod wires
using pliers.