E-flite Carbon-Z Yak 54 3X BNF Basic - Manual (Page 10)

EN
1. Slide the wing tube (A) into the fuselage.
CAUTION: DO NOT crush or otherwise damage the wiring when
attaching the wing to the fuselage.
2. Install the left and right wing (B and C) over the wing tube and into the
wing slot of the fuselage while inserting the aileron servo connectors
through the provided holes.
3. Invert the fuselage so the landing gear is facing up. Secure the left and
right wings to the fuselage using the included screws (D).
4. Remove the screw (E) and the receiver cover (F) from the bottom of the
fuselage.
Tip: If needed, use hemostats or pliers to pull the servo connectors
into the fuselage.
5. Connect the aileron servos from the wings to the Y-harness connectors in
the fuselage. The left and right aileron servos can be connected to either
side of the Y-harness.
6. Replace the receiver cover and the screw.
Disassemble in reverse order.
IMPORTANT: Correct operation of the AS3X system requires connection of
both ailerons to the included Y-harness and the AILE channel of the receiver.
Wing Installation
A
B
C
F
E
Servo Arm Settings
Fly the model at recommended settings before making changes.
The linkages installed at the factory position are chosen for the most
balanced aerobatic response and AS3X performance. Linkage connections
directly affect aircraft response and AS3X performance.
NOTICE: Moving a linkage to another position may block the servo arm or
affect AS3X functionality. Refer to the receiver instructions for more information
about AS3X functionality.
Arms
Elevator
Rudder
Ailerons
D
3 X 18mm (2)
D
10