E-flite F-16 400 DF ARF - Manual (Page 18)

18 E-flite F-16 ARF Assembly Manual
 5. Lift the canopy hatch from the top of the
fuselage. The hatch is held in position using four
small magnets and will take a light amount of force
to remove.
 6. Use 6-minute epoxy to glue the steering servo
mounting block in the fuselage. Note that the notch
in the block faces to the front of the fuselage.
 6. Locate a long 3D servo arm and use side cutters
to remove one of the arms from the horn as shown.
 7. Use a pin drill and 5/64-inch (2mm) drill bit to
enlarge the outer hole on the servo arm.
Note: Before installing the steering servo
arm, it is suggested to read through the Radio
Programming section of this manual found on
Page 30.
 8. Slide the 2mm x 10mm machine screw through
the brass steering arm bushing.
 9. Slide the brass steering arm bushing through
the slot in the steering arm. Note the direction of
the screw in relationship to the steering arm.
 10. Use a #1 Phillips screwdriver to start the screw
into the outermost hole in the servo arm. Tighten
the screw so the brass steering arm bushing is tight
against the servo arm.