E-flite Mini Ultra Stick ARF - Manual (Page 28)

 4. Drill a 3/64" hole in the outside hole of a servo
arm. Install a micro control connector in the hole,
and then secure its location using a micro control
connector backplate.
 5. With the radio on, center the servo first. Then
slide the control connector onto the wire and
install the elevator servo arm onto the servo and
secure with servo screw. Physically center the
elevator so it is in line with the stabilizer. Use a
2mm x 4mm screw in the micro control connector
to secure the pushrod wire.
 6. Repeat Steps 3 through 5 for the rudder
pushrod wire.
28