Wing and landing gear assembly – E-flite T-34 Mentor 25 ePTS RTF manual User Manual
Page 7
7
E-flite T-34 Mentor ARF Assembly Manual
Wing and Landing Gear Assembly
Required Parts
Wing panel (left and right)
Landing gear strap (5)
Flap linkage (fixed flap)
Wing tube
Aluminum anti-rotation pin
3mm x 10mm sheet metal screw (10)
Required Tools and Adhesives
Medium CA
Phillips screwdriver: #2
1. Attach the flap linkage to the flap linkage stay. The
linkage will attach to the third hole.
Note: The flap will be set to the training position in this
section. Setting the flap position for your particular level
of flight skills will be covered later in the manual.
Hint: You can skip steps 1 and 2 if you plan on installing
a servo for the operational flaps. Follow the steps in the
section "Operational Flap Installation (Optional)" instead.
2. Connect the clevis to the flap control horn. You will
note the flap is driven down when you connect the clevis.
We will adjust this position in a few steps.
3. Slice the aluminum anti-rotation pin into the wing. It is
suggested to use medium CA to glue the pin in place to
prevent it from falling out and getting lost.