E-flite Edge 540 BP 3D ARF - Manual (Page 12)

1 E-flite Edge 540 BP ARF Assembly Manual
  4. Slide the hinges and elevator into position on the
stabilizer. Align the end of the elevator with the end of the
stabilizer. Remove the T-pins to position the elevator as
close to the stabilizer as possible while maintaining proper
hinge gap for adequate throw. Saturate each hinge, top
and bottom, with thin CA.
Note: Do not use CA accelerator on the hinges. The CA
must be allowed to soak into the hinges and surrounding
wood to provide the best bond.
Important: Make sure the balance tab of the elevator
clears the end of the stabilizer before applying CA
to the hinges.
 5. Repeat Steps 2 through 4 to install the remaining elevator.
Apply thin CA to the elevator joiner as well as the hinges.