E-flite Extra 260 3D Profile - Manual (Page 26)

2
  8. Locate the 4 1 /
2
" (115mm) pushrod. Install the
“Z” bend into the hole of the control horn that
is one away from the aileron. This will provide
for 3D throws of the aileron. Pass the pushrod
through the connector. Check that the aileron
servo is centered using the radio. Hold the aileron
parallel to the wing and use the 2mm x 4mm
screw in the connector to secure the pushrod wire.
Repeat this for the other aileron pushrod.
Note:.Use.the.hole.in.the.control.horn.closest.
to.the.aileron.for.the.greatest.amount.of.throw..
Moving.the.pushrod.outward,.away.from.the.
aileron,.will.result.in.gradually.decreasing.the.
control.throws.