E-flite Piper Pawnee 15e ARF - Manual (Page 30)

30 E-flite Piper Pawnee ARF Assembly Manual
 19. Position the fin back onto the fuselage. Use a square
to check the alignment between the fin and stabilizer.
Lightly sand the bottom of the fin until the alignment
is correct. Use 30-minute epoxy to glue the fin to the
fuselage. Make sure to check the alignment periodically
to make sure it does not change position during the
curing process.
Main Radio Installation
Required Parts
Receiver Servo w/hardware (3)
Pushrod connector (3) Hook and loop material
Required Tools and Adhesives
Phillips screwdriver: #1 Scissors
Pliers Side cutters
6 minute epoxy Felt-tipped pen
Thin CA Hobby Knife
Drill
Drill bit: 1/16-inch (1.5mm), 5/64-inch (2mm)
 1. Turn on your radio system and select a new model
if using a computer radio. Make sure all the sub-trims
have been set to 0 and no mixing functions are turned
on. Center the trim levers and stick at this time as well.
Plug the servos into the radio system and make sure all
servos operate and are centered.
 2. Prepare the rudder and elevator servos for
installation by removing any unnecessary arms from
the servo horns as shown. Install any grommets or
brass eyelets at this time.