E-flite Mini ShowTime 4D ARF - Manual (Page 11)

11 E-flite Mini ShowTime ARF Assembly Manual
 2. Attach the Outrunner motor to the front of the firewall
using four black #4 washers and four 4-40 x
3 /
8
-inch
socket head screws.
Cowling Installation
Required Parts
Fuselage w/motor installed
Cowling
2mm x 8mm wood screw (4)
Propeller
Spinner
Prop adapter (for outrunner motor)
Electronic speed control
Required Tools and Adhesives
Drill
Drill bit:
1 / 16
-inch (1.5mm), 1 / 8
-inch (3mm)
Card stock
Masking tape
Screwdriver (Phillips #0)
Hook and loop material
Important Information About Your Brushless ESC
Make sure your ESC brake is programmed to Off. Also, be sure
to use an ESC with the proper 9V cutoff when using 3-cell Li-Po
packs, or 6V cutoff when using 2-cell Li-Po packs.
Important Information About Your Propeller
It is also very important to check to be sure the propeller is
balanced before installing onto the shaft. An unbalanced
propeller may strip the gears or cause poor flight characteristics.