E-flite Funtana 300 ARF User Manual
Page 19
19
E-flite Funtana 300 Assembly Manual
4. Use foam-safe CA to glue the remaining nylon wheel
retainer on the landing gear. Use care not to get glue into
the wheel and prevent it from rotating.
5. Repeat Steps 2 through 4 for the remaining wheel.
Note: You may wish to continue on in the manual and
complete the model before gluing on the landing gear
covers and wheel pants to ensure they do not get
damaged during the rest of the construction of the model.
6. Slide the wheel pants onto the nylon wheel retainers.
With your Funtana 300 on the work surface, check that
there is adequate clearance between the work surface
and the wheel pants. Use foam-safe CA to glue the wheel
pants to the wheel retainers.
7. Install the landing gear fairings using hot glue. Place a
dot of glue at the top and bottom of the fairings to attach
them to the landing gear wire.