E-flite UMX Habu S DF180m BNF - Manual (Page 12)

12
EN
Factory Control Horn Settings
The illustration shows linkage positions chosen for
the most balanced aerobatic response. Linkage
connections on the control horns directly affect
aircraft response.
Aileron Elevator Rudder
Post Flight Checklist

1. Disconnect the fl ight battery from the ESC
(Required for safety and battery life).
2. Power OFF the transmitter.
3. Remove the fl ight battery from the
aircraft.
4. Recharge the fl ight battery.

5. Store the fl ight battery apart from the
aircraft and monitor the battery charge.
6. Make note of the fl ight conditions and
fl ight plan results, planning for future
fl ights.
Landing Gear Removal
If desired, remove the landing gear for belly landing
the aircraft in a soft landing area.
1. Lift the end of the main gear wire above
the stop.
2. Gently pull the main gear away from the
fuselage and away from the clips.
3. Carefully pull the nose gear from the mount.
When needed, assemble in reverse order.
Tip: The nose gear strut wire can be twisted a
small amount to adjust the ground tracking.
Always remove the nose gear from the aircraft
before performing this adjustment.