E-flite RV-9 450 ARF - Manual (Page 29)

29 E-flite RV-9 450 Assembly Manual
 4. Use canopy glue to secure the canopy to the
hatch. Use low-tack tape to keep the canopy in
position on the fuselage until the glue fully cures.
Wing Installation
Required Parts
Fuselage assembly Wing assembly
#4 washer (2)
4-40 x 1-inch socket head screw (2)
Required tools
Hex wrench or ball driver: 3/32-inch
 1. Remove the hatch from the fuselage. Position the
wing on the bottom of the fuselage. Slide the wing
forward so the dowels in the leading edge go into
the appropriate holes in the fuselage.
 2. Check to make sure the leads for the aileron
servos (and flap servo) are inside the fuselage.
The wing is held in position using two 4-40 x
1-inch socket head screws and two #4 washers.
Use a 3/32-inch ball driver or hex wrench to
tighten the screws.
 3. Plug the aileron servos into the Y-harness coming
from the receiver. If you are using flaps, plug the
flap servo lead into the 3-inch (76mm) extension
coming from the receiver.