E-flite ElectraJet EP w/ESC & Delta Mix - Manual (Page 8)

8
Step 1. Locate the two vertical stabilizers.
Step 2. Mix an adequate amount of 12-minute epoxy and apply
to the recesses on the fuselage where the vertical stabilizers will
be mounted.
Step 3. Use a pin to hold the vertical stabilizers in place.
(Masking tape can also be used, but remember it can mark the
surface of the foam).
Step 4. The distance between the leading edge of the vertical
stabilizers is 215 mm.
Step 5. Wipe off any excess epoxy with rubbing alcohol and
paper towels.
Assembling the Vertical Stabilizers