ExpoImaging ExpoDisc: Olympus Custom WB - Manual (Page 4)

Olympus E-410
1. Install the ExpoDisc over the front of the cameraʼs lens.
2. Allow the camera to set an automatic exposure using the “P”, “S”, or “A”
modes or set the correct manual exposure in “M” mode.
3. First, you must set the programmable Left-Arrow button for ʻOne Touch WBʼ.
You only need to do this procedure once (steps 3-6). Press the ʻMENUʼ
button on the back of the camera.
4. Push the Down-Arrow to select the wrench I icon (the customize shooting
functions I menu). Then press the Right-Arrow button.
5. Press the Up-Arrow or Down-Arrow button to select ʻLeft Arrow FUNCTIONʼ,
then press the Right-Arrow button.
6. Press the Up-Arrow or Down-Arrow button until the ʻOne Touch WBʼ icon ( )
is selected. Then press the Center (ʻOKʼ) button. The Left-Arrow button is
now set for ʻOne Touch WBʼ. You do not need to repeat steps 3-6 unless you
subsequently change it.
7. Press the Left-Arrow button to engage the ʻOne Touch WBʼ function.
8. While holding the Left-Arrow button, aim the camera towards the light
illuminating the subject and press the shutter release button.
9. Press ʻOKʼ with ʻYESʼ selected to set the ʻOne Touch WBʼ. This white balance
setting will stay in effect until a new custom white balance is registered.
10. If you get the message “WB NG RETRY” this indicates that you need to
adjust your exposure and reattempt to set your white balance.
11. Remove the ExpoDisc and start shooting.
Olympus E-500
1. Install the ExpoDisc over the front of the cameraʼs lens.
2. Allow the camera to set an automatic exposure using the “P”, “S”, or “A”
modes or set the correct manual exposure in “M” mode.
3. First, you must set the White Balance button for ʻOne Touch WBʼ. You only
need to this procedure once (steps 3-6). Press the ʻMENUʼ button on the
back of the camera.
4. Push the Down-Arrow to select the wrench I icon (the customize shooting
functions I menu). Then press the Right-Arrow button.
5. Press the Up-Arrow or Down-Arrow button to select ʻWhite Balance
FUNCTIONʼ ( ), then press the Right-Arrow button.
6. Press the Up-Arrow or Down-Arrow button until the ʻOne Touch WBʼ icon ( )
is selected. Then press the Center (ʻOKʼ) button. The White Balance button
is now set for ʻOne Touch WBʼ. You do not need to repeat steps 3-6 unless
you subsequently change it.
7. Press the White Balance button to engage the ʻOne Touch WBʼ function.
8. While holding the White Balance button, aim the camera towards the light
illuminating the subject and press the shutter release button.
Copyright, 2010 ExpoImaging, Inc.
“Olympus” and the Olympus camera models listed are Trademarks of Olympus, Inc.