Brother BAS-311F-L - Manual (Page 23)

3. INSTALLATION
BAS-311F-0, 311F-L, 326F-0
16
3-16. Installing the programmer (option)
1. Install the programmer support (2) to the work table with the two screws (1).
2. Insert the programmer connector (4) securely into the left side of the operation panel (3).
3-17. Installing the work clamp lifter connecting rod
(BAS-311F-0 solenoid type only)
1. Remove the four screws (1), and then remove the side cover (2).
2. Install the work clamp lifter connecting rod (4) to the screw (3) on the work clamp lifter lever (5).
3. After installing, re-install the side cover (2) with the four screws (1).
Note
Remove chain hooking back (7) which is attached to the work clamp lifter pedal (6) before tilting back the machine
head.
Move the treadle support base (8) back and forth to adjust so that the chain which is attached to the presser lifter
connecting rod (4) and the presser lifter treadle (6) does not touch the cables.
1181S
[Flat]
(2)
(1)
(1)
(2)
(4)
(3)
1182S 1183S
1184S 1185S
(5)
(3)
(4)
(5) (3)
(1)
(2)
(7)
(6)
(8)
[Vertical]