Blue Rhino 450000 - Manual (Page 9)

Step 4 – Attach Corner Columns to Platform
• Hold Platform over Corner Columns and line up holes in Columns
with holes in tabs. Insert Medium Bolt through each hole at top of
Column into tab and finger tighten. Repeat for 3 other corners
making sure columns match positions shown in drawing. Do not fully
tighten until Step 5, where instructed.
Note: Make sure the oblong hole at the center of the platform is directed
closest to the front of the Table Assembly.
Step 5 – Insert Side/Rear Panels
Note: There are different patterns for the Sides and Front/Rear Panels.
Front and rear panel, have handle holes and horizontal vent holes.
Side panels have upside-down v-shaped vent holes. Also notice that
the panel with the Latch at the top and 2 tabs at the bottom is the Front
Door Panel.
• With the brushed side of the panel facing out, slide the Rear Panel
between slots in two Rear Columns as shown, until it rests on base.
• Tighten all of the bolts from Steps 3 & 4.
• With the brushed side of the panels facing out, slide the side panels
into the slots between the front and rear columns as shown until they
rest on the base.
• Secure each panel to clip on platform with Small Screw.
8 Owner’s manual and assembly instructions: model 450000 outdoor patio heater 1/15/03
Contact 1-800-762-1142 for assistance.
Do not return to place of purchase.