GunVault SV 500 - Manual (Page 7)

- 6 -
Installing the SpeedVault:
IMPORTANT: When mounting the SpeedVault make sure the drawer has
enough space to drop open. The drawer requires gravity to fully release, always
install in a vertical position (see image below)
1.
Secure the “Mounting Bracket” to the desired location using the “Wall
Mounting Holes
” on the bracket and the provided wood screws.
IMPORTANT: Mounting screws provided are for solid wood surface only. If
mounting to another surface type, drywall, cement, and etc, the appropriate
hardware can purchased through a local hardware store.
2.
Remove the two “Thumbscrews” located on the bottom of the SpeedVault
(see image below).
3. After removing the two “Thumbscrews”, open the SpeedVault using the
supplied keys. This will allow the drawer to be removed by lifting it up and out.
4. With the drawer removed, the SpeedVault can now be mounted to the bracket.
Insert the “Mounting Hooks” into the “Hook Mounting Holes” located on the
left, right, or back of the SpeedVault. Now that the SpeedVault is mounted to
the bracket, it can be secured to the bracket by using the supplied
“Thumbscrews”.
5.
Locate the three “Thumb Mounting Holes” beneath the “Mounting Hooks”
inside the safe. They will be on the same side as the “Mounting Bracket”.