Brinkmann 1 MILLION CANDLEPOWER 12-VOLT SPOTLIGHT 800-2705-0 - Manual (Page 3)

Screws
OPERATING INSTRUCTIONS
READ AND FOLLOW ALL SAFETY WARNINGS AND INSTRUCTIONS IN THE OWNER’S MANUAL
BEFORE OPERATING SPOTLIGHT.
Step 1: To activate spotlight, plug the cigarette lighter adapter
into a cigarette lighter receptacle.
Step 2: Depress trigger switch in handle to turn spotlight ON.
Release trigger switch to turn spotlight OFF.
WARNING: Never place spotlight lens face down when light is
on or if it was recently on. Doing so could
burn/ignite surfaces such as seats, carpeting, etc.
and cause serious property damage. Always turn
spotlight off and unplug from power source when
not in use.
Step 3: To lock trigger switch to ON, depress trigger switch and
slide locking button on side of handle to LOCK. To
unlock and turn spotlight OFF, slide locking button up to
UNLOCK.
NOTE: The locking button can also be used to lock spotlight in
the OFF position to prevent accidental activation.
To Replace Bulb Only use a Brinkmann halogen bulb that is designed for the
1 Million CP Spotlight as a replacement. Use of any other bulb
may result in poor performance and may damage your spotlight.
IMPORTANT: Do not touch the glass part of bulb with fingers as
natural oils affect the life and performance of bulb.
Handle bulb by metal end only.
Step 1: Disconnect spotlight from power source.
Step 2: Pull out rubber cap. Remove screws from right housing.
(see Figure 1).
Step 3: Holding the left housing securely, slowly lift the right
housing off being careful not to pull wire connections
inside. Do not touch the inside of reflector.
2
FIGURE 1
Locking
ON/OFF
Button
INSTR_800-2705-0_1MCP.qxd 9/26/05 10:59 AM Page 3