Bunn ULTRA-2 PAF - Manual (Page 4)

4
1. Open the Cabinet Door and
allow the support arms to lock
in place.
THOROUGH CLEANING OF THE PAF HOPPER (Once a week)
2. Slide the gate shut on the
powder hopper and remove the
hopper. Remove the Cover and
empty the contents.
3. Pull the Ejector Elbow off the
Hopper Base. Remove the Slide
Gate from the Ejector Elbow.
4. Remove the Wiper Blade and
Drive Gear by removing the
Retaining Ring from the Wiper
Blade Shaft. Remove Auger by
pulling it out the front of Hop-
per Base.
5. Remove the Auger Drive Shaft
by turning the screw of the Au-
ger Drive Bracket in a clockwise
direction.
6. Wash all components in a mild
solution of dish detergent using
a bristle brush when needed.
Rinse and dry each item thor-
oughly before reassembling.
NOTE: Parts must be thoroughly
dry before adding powder to the
hopper.
43553 071410