Bissell 3554 - Manual (Page 7)

Tip:
Before cleaning
under low furni-
ture, check for
objects that
might harm the
rotating floor
brush or block
the vacuum
hose. Do not
pick up hard or
sharp objects
such as glass,
nails, screws,
coins, paper
clips, etc.
Cleaning carpet, rugs or bare floors
Press the Handle Release Pedal with your foot to change
your Lift-Off from full upright/above floor cleaning
position to normal carpet cleaning position, or for low
cleaning under beds and low furniture. Always store or
transport in the full upright position, rolling the cleaner
on rear wheels only.
Handle Release Pedal
Cleaning with the Detachable Canister
CAUTION:
Always
place vacuum cleaner on
floor in its fully upright
position, and make sure it is
locked into place before
removing Canister or when
using tools. Placing the
Lift-Off in its full upright
position automatically stops
the rotating brush, and the
headlight will turn off.
7
When you are done cleaning, return your
Lift-Off to the Upright position and store the
Power Cord.
1. Turn vacuum cleaner OFF.
2. Unplug Power Cord by grasping the
polarized plug (NOT the cord) and dis-
connect from outlet.
3. Loop Power Cord around Cord Wraps on
the side
of Canister.
4. Clip molded plug to Power Cord to secure.
Powercord Storage
The Detachable Canister feature makes it possible to take
the powerful cleaning action of your BISSELL Lift-Off to
stairways, auto interiors, or other hard-to-reach areas of
your home.
Before detaching the Canister, your
Lift-Off must be in its fully upright
position. You do not need to turn off
the power first.
1. Press the Lift-Off Release Latch at
the back of the Chassis and lift
the Canister to remove.
2. Detach the Vacuum Hose from
the port at the back of the
PowerFoot.
3. Press fit the desired tool to
the end of the Vacuum Hose.
4. When you’re done, return
the Canister to the
Powerfoot/Chassis by sliding
it straight down the Chassis
over the power port and
remove the tool used.
The Lift-Off Latch will lock
the Canister in place.
Reconnect the Hose to
the vacuum port.