Human Touch HT-103 Massage Chair - Manual (Page 5)

humantouch.com
8 9
ENGLISH
3. Adjust the backrest
Use the remote control Recline and
Incline settings to adjust the backrest
angle for maximum comfort.
When changing backrest or foot and calf massager direction, there is a slight pause while the chair gears shift.
This is perfectly normal.
2. Adjust the footrest height
While sitting in the chair, pull up on the
footrest control lever (located on the right-
hand side of the chair) to allow the footrest to
rise to a comfortable height. Release the lever.
take a seat
1. Deploy the foot and calf massager
FOR A FOOT OR CALF MASSAGE
Using your Human Touch massage chair is easy. Just take
a seat and adjust the backrest and foot and calf massager
to the desired position. Your Human Touch
massage chair
helps you feel better from head to toe, using a wide variety
of massage techniques that you control. It’s the perfect
way to relax and refresh.
2. Insert your feet or calves
Pull up on the footrest rotation release handle (located on the right-hand
side of the footrest).
For a calf massage, rotate the footrest away from the chair until it clicks
into position with the foot and calf massager facing up.
Do not force the
rotation of the footrest past the point at which it clicks to lock. Excess
force may damage the mechanism.
For a foot massage, rotate the footrest away from the chair just until the
foot and calf massager is facing up. Do not rotate it so far that it clicks
into position; the footrest should be moving freely for a foot massage.
Before getting out of the chair, always lower the footrest.
Pull up on the footrest lever (located on the right-hand
side of the chair) then use your calves to push the
footrest down into a vertical position.
Do not stand or sit on the foot and calf massager.
To collapse the chair for moving, press down on the backrest release lever, located on the back of the
chair under the rear right-hand corner of the seat, then push the backrest down onto the chair seat.
1. Power on
Plug the power cord into a grounded 120-volt
power source. Turn the master power switch (on
the bottom center of the backrest) to On.