Human Touch iJoy 300 Robotic Massage Chair - Manual (Page 6)

11 10
www.ijoy.com
MASSAGE MODES
Kneading – kneads your back in small, circular motion on both sides
of your spine simultaneously, relieving tension and soreness by lift-
ing and stretching muscles. Kneading improves circulation and helps
bring vital nutrients to the spinal area.
Percussion – alternating rapid-tapping strokes along the spine
stimulate both spinal muscles and spinal joint areas, emulating the
percussive massage technique used in sports medicine for deep
muscle therapy. Percussion massage flexes spinal joints and relieves
pressure on the spinal column, invigorating the entire back area.
Compression – presses on spinal muscles and spinal joint areas
using alternating strokes and a gentle rocking motion, emulating a
technique used in sports medicine and in spinal therapy by chiroprac-
tors. Compression spreads and puts pressure on deep muscle tissue,
forcing it to relax, while the rocking motion loosens spinal joints. This
technique aids in muscle and joint repair due to strain from exercise,
long hours bent over a desk, or just day-to-day stress, and can
improve mobility and overall posture.
Rolling Full – rolls gently up and down your back near your spine,
gently alternating side-to-side, to warm up and loosen your muscles
and prepare your back for deeper massage. Rolling massage relieves
muscle tension, improves circulation and relaxes the back.
Rolling Partial – The same feel and benefits as described in
“Rolling” that can be applied in a single area. Use the Manual Positon
up & down buttons to apply the massage in the desired area.
Stationary Massage Modes
Stationary Massage Modes
Massage Programs massage the specified area of
your back for 15 minutes, using a variety of massage
techniques. The corresponding LED lights on the remote to
indicate which massage mode is currently in use.
Full – massages your entire back
Upper – massages just your upper back
Lower – massages just your lower back
Manual Position (up/down arrows) – Use this button
along with one of the stationary massage modes, to
set the massage rollers to the desired position on the
backrest. You can press this button before or after
selecting the massage mode.
Power – lights red to indicate that master power switch
is on
Stop/park – stops the massage and parks the massage
rollers at the top of the backrest
Now choose a massage mode to
suit your mood!
You can choose one of
the four specific back massage modes. Or you
can choose one of the three back massage
programs, which alternate between massage
modes and target different areas of your back.
Got a specific spot that’s sore? You can position
the back massage rollers to target that spot.
TAKE CONTROL
Stationary Massage Modes
Back Angle – Use this button to adjust the backrest and calf
+ foot massager angle for maximum comfort.
Use rolling modes on their own
or along with a stationary mode