Human Touch PC-410 Perfect Chair - Manual (Page 4)

5
humantouch.com
4
get ready
ATTACH THE ARM CAPS
Remove the three screws taped to the underside of the right-hand
arm cap, then place the right-hand arm cap on top of the armrest.
From the underside of the armrest, secure the arm cap using the
three screws. Repeat these steps to attach the left-hand arm cap.
Slide the head sock over the headrest frame, as far as it
will go. The padded side of the head sock should face
the back of the chair.
ATTACH THE HEAD PAD
1. Slide the head sock over the headrest frame.
Slide the head pad over the head frame, ensuring that the frame
slides into the fabric pocket located on the bottom side of the
pad. Pull the head pad down as far as it will go.
2. Slide the head pad over the head frame.
From the front of the chair, tuck the flap on the top of the body pad
up into the head pad and smooth it flat. The flap is automatically
secured to the pad, using the hook and loop fasteners.
3. Tuck in the body pad flap.
Attach the head pillow straps to the head pad straps using
the hook and loop fasteners. Adjust the head pillow height for
maximum comfort.
4. Attach the head pillow.
1. Raise the chair to an upright position.
ATTACH THE HEADREST FRAME
For your convenience, and to better position the chair for the remaining assembly,
use the recline lever to adjust the chair to an upright position.
Using the Phillips-head screwdriver (provided), remove the two
screws from the headrest frame. Retain them for use in step 4.
Using a Phillips-head screwdriver, replace the two headrest frame
screws, securing the headrest frame to the backrest frame.
2. Remove the headrest frame screws.
3. Insert the headrest frame into the backrest frame.
4. Replace the headrest frame screws.
With the arc of the headrest frame pointing toward the back of the chair, slide
the two ends of the headrest frame into the open tube ends at the top of the
backrest frame.