JK Audio ComPack - Manual (Page 3)

14
Your new JK Audio product has been registered with the Federal
Communications Commission (FCC). This product complies with
the standards in Part 68 of the FCC rules.
1.
Connection and use with the nationwide telephone
network
The FCC requires that you connect this telephone equipment
to the national telephone network through a USOC RJ-11C
modular telephone jack.
This equipment may not be used with Party Line Service or
Coin Telephone Lines.
This equipment is hearing aid compatible.
2.
Information for the telephone company
Upon request from your local telephone company, you are
required to provide the following information:
a) The "line" to which you will connect the telephone
equipment (that is, your telephone number), and
b) The telephone equipment's FCC registration number.
This can be found on the bottom of your t e l e p h o n e
equipment, and,
c) The ringer equivalence number (REN) for this
equipment. The REN is used to determine the quantity of
devices which will be connected to the telephone line.
Excessive RENs on the telephone line may result in the
devices not ringing in response to an incoming call. In most,
but not all areas, the sum of the RENs should not exceed 5.0.
To be certain of the number of devices that may beconnected
to the line, as determined by the total RENs, contact the local
telephone company.
3. Repair Instructions
If it is determined that your telephone equipment is
malfunctioning, the FCC requires that it not be used and that it
FCC Registration
3
ComPack General Operation
1. Connect your microphone (and/or line input) and head-
phones to the input and output jacks on ComPack.
2. (a) Connect the jack marked "Phone Line" to any
standard analog telephone line, or
(b) Connect the “Wireless Phone Headset Jack” to the
2.5 mm headset jack on your cellular telephone using
the supplied cable, or
(c) Disconnect the handset on an existing telephone and
plug the coily cord from the phone into the “Universal
PBX Handset Interface” jack on ComPack.
3. Turn on the power switch, flip the phone line switch to
dial/talk*, flip the keypad switch to on*, and dial your call.
*When using the wireless phone or PBX handset interface,
the phone line switch should be left in the Hang Up position
and the Keypad switch should be in the off position. All Dial-
ing and answering of calls in these modes must be done from
the telephone itself.
2. (a) Standard
analog phone
line
2. (b) Cell Phone con-
nection using wireless
phone cable provided
2. (c) Handset jack on
PBX telephone. Set A-B-C
switch for best audio.
OR OR