JK Audio PBXport - Manual (Page 3)

14
This equipment has been tested and found to comply with
the limits for a Class A digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential
area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own
expense.
Changes or modifications not expressly approved by JK
Audio can void the user's authority to operate the equipment.
FCC Registration
Your new JK Audio product has been registered with the
Federal Communications Commission (FCC). This product
complies with the standards in Part 68 of the FCC rules.
1. Connection and use with the nationwide telephone
network
The FCC requires that you connect this telephone
equipment to the national telephone network through a
USOC RJ-11C modular telephone jack.
This equipment may not be used with Party Line Service
or Coin Telephone Lines.
This equipment is hearing aid compatible.
2. Information for the telephone company
Upon request from your local telephone company, you
are required to provide the following information:
a) The "line" to which you will connect the telephone
equipment (that is, your telephone number), and
b) The telephone equipment's FCC registration number.
FCC Part 15 Compliance
3
1. Handset Button - Press this button to use the handset as on a normal
phone call.
2. ON LED - Lit when you are online with a call using the digital hybrid.
3. Online Button - Press this button to disable the handset and activate the
PBXport for use as a digital hybrid.
4. Send LEDs - Displays the signal level going out to the telephone line.
5. Send Level - Adjusts the signal level that you are sending down the tele-
phone line, through the female XLR input.
6. Caller Level - Adjusts the level of the signal coming in from the telephone
line, going out the output jacks.
7. Send>Mix Level - Adjusts the level of local Send audio going out the Mix
output jack.
8. Mix<Caller Level - Adjusts the level of signal coming in from the tele-
phone line, going out the Mix output jack.
9. Mix Monitor jack - 1/4" stereo headphone jack containing the same mix
as the Mix output jack.
10. Mix Monitor Level - Adjusts the signal level of the 1/4" headphone jack
and the speaker terminals.
11. Front Panel Handset Jack - Connect your telephone handset to this jack
or the rear panel handset jack.
12. Front Panel Phone Jack - Connect the handset jack on your telephone
base to this jack or the rear panel phone jack using the supplied handset
jumper cable.
13. Power LED - Lit when the unit is plugged in and receiving power.
14. Receive LEDs - Displays the signal level coming from the phone line,
after the DSP.
15. Handset Type Selector Switch - Use this switch to select the correct type
of handset microphone that your telephone uses. A=Electret, B=Carbon,
C=Dynamic.
Features—Front View
1 2 3 4 5 6 7 8 9 10 11 12
13 14 15