JK Audio QuickTap IFB - Manual (Page 4)

4
FAQ’s
? What kind of earpiece should I use with the
QuickTap IFB?
! Any standard earpiece should work fine as long
as it has an impedance greater than 600 ohms.
? I want to send the QuickTap IFB's XLR out-
put to an auxiliary input of my mixer but I'm
not getting any audio. What's wrong?
! The QuickTap IFB is a passive device that out-
puts a mic level signal. You'll need to send the
output to a mic input on your mixer.
? How do I adjust the level of the XLR output
on my QuickTap IFB?
! The attenuator on the QuickTap IFB only ad-
justs the 1/8" earpiece jack. The male XLR pro-
vides a fixed level 600 ohm output.
? I'd like to use a pair of headphones with my
QuickTap IFB. Is this possible?
! The QuickTap IFB is a passive device and will
not power a pair of headphones. You'll need to
use a JK Audio RemoteAmp with it. The Re-
moteAmp will take the balanced output from the
QuickTap IFB, amplify it and send it to a 1/4"
headphone jack and a 3.5 mm output jack.
5
Specifications
Mini Output :
Connector 1/8" Mono jack
Output Impedance 600 ohms
Output Level 100 mV RMS
Isolation 1500 VRMS
XLR Output:
Connector
Male SLR Jack
Output Impedance 600 ohms
Level 100 mV RMS
Isolation 1500 VRMS
Handset and Telephone connectors:
Modular 4pin/4wire handset jacks
Compatibility Note: Not all telephones are
built alike so we cannot guarantee QuickTap
IFB will work with every handset design out
there. We designed QuickTap IFB to work
with most popular telephones.
QuickTap IFB is not for use with cellular
phones or telephones that have a keypad built
into the handset.