JK Audio THAT-1 - Manual (Page 5)

5
FAQ’s
? I have been using my THAT-1 for recording and it
works great but when I try to send audio down the
line it won’t work.
! Several things could be causing this problem: First you
must send a line level signal into the “To Phone” jack on
THAT-1. Second, make sure the gray button is in the “In”
position. This disables the handset mic and enables the
audio input. Third, the phone you are using must have an
“electret” type mic in the handset. Not all phones are the
same and THAT-1 is only compatible for sending audio
with phones that have this microphone type. You may
want to consider our THAT-2 which has a three position
switch to allow you to use it with virtually any telephone.
? Can I get an adapter that will allow me to connect
THAT-1 to the wall jack instead of the phone?
! No, your THAT-1 doesn’t replace your phone,, but works
in conjunction with it. You will need to plug it in between
the telephone base and the telephone handset.
? What is the gray pushbutton on THAT-1 used for?
! The button is used to select which audio signal will be
sent into the telephone.
OUT = talking on the handset
IN = sending audio through the RCA jack
Keep in mind that you cannot send audio into the RCA
jack and talk on the handset at the same time. However,
any audio sent into the phone can be heard on the hand-
set and is available on the RCA output jack at all times.