LandAirSea GPS Tracking Key Pro Quick Start Guide - Manual (Page 4)

QUICK START GUIDE - Downloading Data
Preparing to download.
Remove the protective cover from the front of the unit. This will expose the
USB plug.
Check your batteries
Ensure that you have fresh batteries in your unit. After long tracking sessions
the batteries in your unit may be worn down.
As your batteries approach low levels, the GPS performance may decrease and
the battery indicator will turn red. At this point you may not be able to
download your information off of your unit. If you are having difficulty
downloading your unit always change the batteries out before you do
anything else.
Step 1
Plug the Tracking Key into your computers USB port.
Be sure that you have completed all of the steps on the “Software
Installation” before proceeding any further.
Remove the protective cap from your Tracking Key and plug it into your
computers USB port. Give your computer about 10 seconds or so to properly
detect. If you have sound on your computer, you will hear a tone.
Step 2
Finding your device.
Run Past-Track by double clicking on the Past-Track icon which you should be
able to find on your Desktop.
Click on the in the Icon Bar.
A new screen will appear. Now click the button called Find Port.
You should get the message saying “Device Found”. Hit OK.
If you receive the message “Device Not Found” please refer to the trouble
shooting guide for corrective actions.