OSD Audio IWS-8 - Manual (Page 3)

comparable to the speaker’s power handling. Please refer to your owner’s
manual for reference.
(See Diagram 7)
Note: Speaker terminals have corresponding (+) and (-) terminals. It is
important to connect both speakers in phase. Out of phase will result in
thin sound and weak bass. (See Diagram 6)
Diagram 6:
Terminal identification
Warranty & Repair
All OSD AUDIO speaker products have (10) year Limited Warranty against defects in materials and workmanship. Proof of purchase must accompany all claims.
During the warranty period OSD AUDIO will replace any defective part and correct any defect in workmanship without charge for either parts or labor
are not OSD AUDIO’s responsibility.
For this warranty to apply, the unit must be installed and used according to its written instructions. If necessary, repairs must be performed by OSD AUDIO. The unit
must be returned to OSD AUDIO at the owner's expense and with prior written permission. Accidental damage and shipping damage are not considered defects, nor
is damaged resulting from abuse or from servicing performed by an agency or person
OSD AUDIO sells products only through authorized dealers and distributors to ensure that customers obtain proper support and service. Any OSD AUDIO product
purchased from an unauthorized dealer or other source, including retailers, mail over dealers and online sellers will not be honored or serviced under existing OSD
AUDIO warranty policy. Any sale of product by an unauthorized source or other manner not authorized by OSD AUDIO shall void the warranty on the applicable
product.
Damage to or destruction of components due to application of excessive power voids the warranty on those parts. In these cases, repairs will be made on the basis of the retail
value of the parts and labor. To return for repairs, you must email customer service at [email protected] for a Returned Merchandise Authorization (RMA) number# then
the unit must be shipped to OSD AUDIO at the owner's expense, along with a note explaining the nature of service required. Be sure to pack the speaker(s) in a corrugated
container with at least 3 inches of resilient material to protect the unit from damage in transit.
This Warranty Does Not Cover:
Damage caused by abuse, accident, misuse, negligence, or improper operation (installation) • • Any product whose
identifying number of decal, serial #, etc. has been altered, defaced or removed • Normal wear and maintenance.
+ +
+ -
Next, individually turn each of the
screws (Diagram 5) that operate the
dogears counter clockwise a few turns
until you feel the dogear is loose from
the resting position. Then turn the
scew clockwise until you feel the
dogear makes contact with the wall
surface.
Screw
Screw
Diagram 5:
TIP: Blown-in insulation can some-
times work its way into the moving
components of the speaker and
negatively impacting performance. It
is best to replace about a one square
foot section directly behind the
speaker with rolled-in (bat) insulation.
(See Diagram 5)
Subwoofer Amplifier
+
Diagram 7:
-
+ +
Power Handling (25 Watts) Minimum
+ -
Note: The speakers wire should be about the same lenght. if
excess wire behind the wall