OSD Audio BTR-800TT - Manual

Rock Speaker
Rock Speaker - Bottom View
AC Power Supply
100-240V
B
A
100-240V
Power Supply
for Rock Speaker
Rock
Speaker
C
D
BTR-800TT
All Weather Bluetooth Rock Speakers
Quick Start Guide
1) Verify the Contents
A. Place Rock Speaker near 12 volt AC outlet so the Power Supply can be connected.
This will provide electrical current needed for the Internal Amplifier & Bluetooth Receiver.
B. Make sure that the Power Supply Block will NOT be sitting in water.
C. The speaker wire can be cut down for an exact fit but should NOT be extended beyond 13-feet.
D. Turn power button on. Red LED indicator light will light up when power is on.
1) DC to AC In
2) Red LED Indicator
3) On/Off Power Button
Bottom View
“Wireless” Bluetooth Operation
connects to any Bluetooth-enabled
device such as smart phones,
tablets and laptop/computers.
Bluetooth Range May Vary:
Line of Sight
120 to 150 feet (Unobstructed)
50 to 75 feet (Obstructed)
3) Pair Bluetooth Device With BTR-800TT
A. Make sure both your Bluetooth device and
the BTR-800TT are turned on and charged up.
B. Find Bluetooth controls. Typically found in the
devices’ Settings or Connections menu.
C. The BTR-800TT will output a Bluetooth Sync
code that will be received by your Bluetooth
device. Sync device.
D. Once synced, the controls (such as volume,
mute, etc.) will be done directly from your
Bluetooth device.
Note: The BTR-800TT can only sync with one device
at a time. You must disconnect the current device
before syncing to another device.
OSD Audio
775 Columbia St. • Brea, CA 92821
(888) 779-4968• www.osdaudio.com
2) Plug Rock Speaker into Power Source:
Ideal for Lawn
and Garden Placement
2 1 1 3