Photoflex FV-XT2MLDKIT Medium LiteDome Deluxe Kit - Manual

Visit photoflex lightingschool .com® for the best free learning resource! For detailed specifications, product tutorial videos and more, please visit www.photoflex ® .com
PROFESSIONAL PHOTOGEAR
Medium LiteDome ® Deluxe Kit Instruction Manual • Item #: FV-XT2MLDKIT
Medium LiteDome ® Deluxe Kit
Before assembling your Small LiteDome ® , make sure all
components are present. You will need:
• Medium LiteDome ® Softbox (A)
• BasicConnector (B)
• Adjustable ShoeMount Hardware (C)
• Aluminum Swivel (D)
• Medium LiteStand (E)
Attach Adjustable ShoeMount to the BasicConnector
1. Use the smaller threaded end (1/4”-20) of the reversible
stud to attach the ShoeMount hardware to the brass
threaded hole in the BasicConnector (Fig. 1). There
is a guide pin at the top of the bracket which lines up with
the untapped holes adjacent to the brass threaded hole
for added stability (the guide pin is removable for use with
other connectors that don’t have guide holes).
2. A screwdriver can be inserted into the pass hole in the
stud to assist in tightening the ShoeMount hardware.
A wrench can also be used on the flat surfaces of the stud.
The ShoeMount hardware should extend out from the side
(Fig. 2).
Attach LiteDome Softbox to the BasicConnector
3. The softbox includes four rods. The rods should already
be inserted into the interior sleeves of the softbox (Fig. 3).
We recommend leaving the rods in the sleeves during
storage. It is normal for them to develop a slight bend
where they attach to the BasicConnector.
4. If closed, open all four Quick Release Corners (QRC).
Pull the Velcro ® tab open at each corner so the rods
extend freely (Fig. 4).
5. Each of the rods will fit in a corner hole of the
BasicConnector (Fig. 5). Be sure each rod seats all the
way into its connector hole. Start with any hole, then
connect the rod directly opposite the starting rod (Fig. 6).
Then insert the rest of the rods (Fig. 6a).
6. After the rods are inserted into the connector, secure the
QRC Velcro® corners. Use one hand to pull the QRC flap
over the rod tip while pushing the rod into place with your
thumb (Fig. 7). Secure the flap to its Velcro® counterpart.
Repeat this process for each of the corners (Fig. 8).
Figure 1.
Figure 4.
Figure 2.
Figure 3.
Figure 5. Figure 6.
Rev 12/12/12
A B
D E
C
Pin
Stud
Figure 7. Figure 8. Figure 6a.