Photogenic Professional Lighting Horizon Continuous Lighting User Manual
Page 2
2
Thank you for selecting the Photogenic Professional Horizon
™ Brand
Fluorescent light. The Horizon
™ Brand Fluorescent series incorporates the
newest electronic technology providing improved lighting. These products are
built for the demanding operational needs of the professional photographer and
it is our expectation that your Horizon
™ Brand Fluorescent light and accessories
will provide you with years of dependable service. The Horizon
™ Brand
Fluorescent lights are self-contained light units. They have plug-in lamps, easily
accessed under a diffusion panel.
SAFETY PRECAUTIONS
1. Before installing or removing lamps, be sure this appliance is turned off,
cooled and unplugged from AC power source.
2. Do not touch the glass lamps with bare hands. Always use a clean cloth or
wear gloves to protect your hand from glass breakage and heat.
3. Do not defeat the purpose to the three-wire line cord by disconnecting the
ground. Connect to properly functioning and grounded 3-pin receptacles
only. If you are using an extension cord, be sure the cord has an equivalent
or greater rating and has a ground.
4. Do not operate this appliance with a frayed or damaged line cord. When
replacing or using the unit with an extension cable, be sure the cable has an
equivalent or greater rating and is a properly connected 3-wire grounded
cable.
5. Do not attempt to use this appliance if it has been dropped or damaged, until
a qualified service person has serviced it.
6. Do not operate the unit with a damaged or broken lamp. Do not use lamps
with broken, cracked or missing bases. To prevent damage or injury always
use Photogenic specified replacement lamps.
7. Perform no internal service work on this unit. Refer all such service to a
qualified service person or return to the factory. This will provide you
safety and continuation of your warranty.
8. Do not operate when water is present and from extreme temperature shifts.
If the unit is stored in hot or below freezing temperatures, allow at least one
hour at room temperatures before using.