Photogenic Professional Lighting Powerlight Manual (various) - Manual (Page 24)

ADVANCED PL2 SERIES ACCESSORIES
All PowerLights must have PLDIR-2 infrared receivers and have their unique unit
numbers assigned. PowerLights may have identical unit number numbers, if they
are to be operated exactly the same, under all studio arrangements.
Select a Unit Number on one of the top ten buttons, then control the PowerLight
with the lower buttons, observing the PowerLight digital display for the changes.
The All button, under Unit Number, transmits the changes to all active PowerLights.
This enables the photographer to raise or lower flash or model levels on all the
units, without the laborious task of changing them all, individually.
STANDBY lets the photographer put all the PowerLights into a standby state to stop
public photographers from slaving the units at a wedding, or some studio units can
be put in standby when not required for a shot. The infrared control can easily
reach to units on 12-foot stands (it has been tested to 100 feet, indoors).
PLIBM-2 Studio System Controller software for IBM compatibles
(must be used with PL1250DR and PL2500DR with PLDIR-1
receivers).
Along with infrared transmitter hardware and an IBM compatible computer using
Windows 95 or 98, the software is used by the photographer to specify the
PowerLight settings for up to nine units with independent settings and save a studio
settings or as a pose file. An unlimited number of pose files my be saved. All
PowerLights must have PLDIR-2 infrared receivers. Instructions are included with
the PLIBM-2 software.
PLX-5 Five foot extension cable with adapter for PLDD-1, PLDRC-1 and
PLDIR-1 displays .
PLX-10 Ten foot extension cable with adapter for PLDD-1, PLDRC-1 and
PLDIR-1 displays .
PLX-15 Fifteen foot extension cable with adapter for PLDD-1, PLDRC-1 and
PLDIR-1 displays .