Photogenic Professional Lighting Solair - Manual (Page 6)

6
Functional Operation
Solair
!
Constant-Color PL500DR & PL1000DR
Voltage Smart# Solair
!
Constant-Color PLX500DR & PLX1000DR
Power Switch:
The power switch controls the AC power to both the modeling and flash circuits. You
have the option to turn-off the modeling circuit independently.
Flash Power:
When the power is turned on the red LED is illuminated. You adjust the PowerLight
Flash power settings by pressing the 1/2 or 1/10 f-stops UP/DOWN arrow buttons. The
watt second settings will be displayed. (If the adjust button is pressed again the modeling
circuit and yellow LED will be turned on.)
Ready Light:
The Solair Constant-Color 1000DR &X1000DR models are fully charged when the
READY lamp is on. Lowest power (7.8ws) setting charge time is a maximum of .8
seconds and at full power charge (1000 ws) time is a maximum of 3 seconds. The unit
may be flashed before fully charged. When adjusting flash power settings downward the
units will bleed stored power until the lowered power setting is reached, the ready light
will then be re-illuminated.