Photogenic Professional Lighting StudioMax II - Manual (Page 4)

4
The 7 ½ inch reflector is attached by the “quick-change” mechanism. A solid tab
and a thumb screw on the unit grip the ring on the reflector. To mount the
reflector, loosen the thumb screw so it does not show inside the circle and tilt the
reflector past the stationary top-tab, then past the thumb screw. Tighten the thumb
screw, securing the reflector (see illustration below.) All accessory reflectors and
soft boxes are designed for use with this “quick-change” system or onto this 7 ½
inch reflector.
With power switch OFF, attach the line cord to the power-input connector,
located on the bottom of the Studio Max II, and connect it to a grounded
wall outlet. Turn the power switch ON. The READY light will light when
the unit has charged.
Thumb screw to hold reflector.
Umbrella holder (shaft passes
through knock-out in reflector.)
Thumb screw for umbrella shaft.
AC line cord jack.
Modeling lamp.
Flashtube.
Reflector, soft box,
bare bulb, or other
“quick-change”
attachments.