Powers 410-0063 Series PressureGuard - Manual

TECHNICAL INSTRUCTIONS
The Powers Pressureguard is installed on the inlets to a water
fixture (shower faucet set, shower mixer, shampoo sink, etc.). It
serves to balance out any pressure fluctuations or differences
in pressure between the hot and cold water lines.
The outlets of the Pressureguard must go directly to the fix-
ture which it serves with no branches to other fixtures. (See
figure above).
MOUNTING POSITION
1. Unit may be mounted in a"y position (vertical, horizontal,
etc.).
2. Mounting should allow access for bonnet removal (3 inch
min.)
3. Provide access panel or door for concealed installations.
PIPING
1. Inlets are 1/2 inch female pipe threads in body.
2. Outlets are 3/8 inch female pipe threads in bonnet.
3. Outlet fittings for use with 1/2 inch O.D. Copper piping pro-
vide a union style. of connection and are provided with unit.
4. Hot water may enter either inlet.
5. Hot water outlet is on the same side as hot water inlet.
CARTRIDGE REMOVAL
1. Disconnect outlet fittings.
2. Remove four bonnet screws.
3. Pull bonnet straight off body (and couplings).
4. Pull or pry cartridge straight out of body.
5. Clean and flush piping before re-installing.
CARTRIDGE REPLACEMENT
(Kit No. 410-248)
1. Lubricate internal sides of body with light grease or soap.
2. Place large O-rings in grooves on side of cartridge.
3. Align cartridge so cartridge inlets lined up with body inlets.
4. Slide cartridge straight into body casting.
5. Place new gasket on bonnet.
6. Slide bonnet onto couplings and press firmly.
7. Install the four bonnet screws.
8. Reconnect outlet piping.
NOTES
(1) Both water pressures must be present for unit to function; loss
of one water pressure will result in the other water pressure
being shut off.
(2) Water capacity is 6 GPM for each side (12 GPM for both) at 45
PSI pressure differential and 1/2
″
pipe connections.
(3) See figures above for roughing-in dimensions.
TECHNICAL INSTRUCTIONS
Pressureguard Pressure Balancer
Product 410-0063
Form TI410-PG V1
A Watts Industries Co.
USA office: Phone: 800.669.5430 • Fax: 847.824.0627
www.powerscontrols.com
Canadian office: Phone: 888.208.8927 • Fax: 888.882.1979
© 2003 Powers, a Watts Industries Co. A Watts Industries Co.
Form TI410-PG 0315 EDP# 6508920 Printed in U.S.A.