Powers 440 Series Fotoguard User Manual
Installation instructions
1.
Flush all piping thoroughly before installing.
2.
Facing front of mixer, connect hot water to left side
(marked HOT) and cold water to right side (marked
COLD). Inlet connections must be piped correctly for
proper operation of Fotoguard.
3.
If copper tubing is used, do not apply heat within 12”
(30.5 cm) of Fotoguard. Excessive heat will damage
internal parts of Fotoguard.
INSTALLATION INSTRUCTIONS
SERIES 440 FOTOGUARD AND
440 SUPPLY FIXTURES
A Watts Industries Co.
INSTALLATION INSTRUCTIONS
SERIES 440 STANDARD FOTOGUARD - CONCEALED
SERIES 440 STANDARD FOTOGUARD - FOR EXPOSED PIPING
SERIES 440 FOTOGUARD HIGH CAPACITY
440-SUPPLY FIXTURES
Dimensions - inches (millimeters)
A=13/8” (35)
B=13/4” (44)
Piping dimensions above are the same
for both the 131-1575 and the 131-1813.
Form 129-008