Powers 900 Series Biltmore Series Pressure Balancing Mixing Valves - Retrofit User Manual
Installation instructions
TO INSTALL
1. Remove “A” (Bonnet nut) and “B” (Bonnet assembly).
2. Remove old cartridge “C”.
3. Apply Silicone Grease to areas indicated by the arrows.
4. Place adapters onto back of cartridge.
5. Place “C” (Cartridge assembly) into valve body. Be careful
to align adapters with holes in the body.
6. Replace “B” (Bonnet assembly). Note that the word “TOP”
is stamped into the stem. Make sure the word “TOP” is
facing upward.
7. Replace “A” (Bonnet nut).
INSTALLATION INSTRUCTIONS
BILTMORE SERIES 900
Pressure Balancing Valves
A Watts Industries Co.
© July 2000 Powers Powers, a Watts Industries Co.
3400 Oakton Street, Skokie, IL 60076 Phone: 800.669.5430 • 847.673.6700 • Fax: 847.673.9044
www.powerscontrols.com
5435 North Service Road, Burlington, Ontario, L7L 5H7 Canada • Phone: 888.208.8927 • Fax: 888.882.1979
A Watts Industries Co.
Form
II900RC
Form
II900RC 0218
EDP# 6507725
Printed in U.S.A.