Powers e700 Series Combination T/P Tempering Valves - Cartridge Only - Manual

e700 CARTRIDGE REPLACEMENT INSTRUCTIONS
The following instructions explain how to replace the
cartridge to your Series e700 valves:
Disassembly:
1. Turn off hot & cold water supply-stops.
2. Remove the handle and trim plate.
3. Remove bonnet.
4. Remove all internal components from the valve body.
5. At this point you should have an empty valve body.
You are now ready to put the new cartridge into your
existing valve.
Reassembly:
1. Ensure the inside of the valve body is free of deposits
and debris. Clean as necessary.
2. Place the cartridge into the body ensuring following:
a) "C" on the cartridge should be on the cold inlet
side.
b) Align tab on the back of the cartridge to the groove
in the body.
3. While holding cartridge firmly, screw bonnet into body;
tighten to 100 + 20/-0 in-lbs.
4. Turn the hot and cold water supplies back on and verify
there is no leakage.
Maximum Temperature Setting/Handle Rotation Stop
The handle rotation setting must be adjusted to limit the dis-
tance the user can rotate the handle towards the full hot
water position.
CAUTION: Any repair or modification of the valve may affect
the high temperature setting. The maximum temperature
setting must be checked by the installer before use.
5. Adjust the valve to the desired maximum outlet
temperature [110°F (43°C) max]. Screw on the high
temp. limit stop until it touches the stem shoulder.
6. Turn the stem clockwise until the water stops. Open
valve to full hot position and verify max outlet
temperature setting.
7. (a) For e707
1. Install the trim plate.
2. Snap-on the indicator plate. Guide on the back of
the plate goes into the locator hole.
3. Install O-ring on the bonnet, slide sleeve on the
bonnet.
4. Install handle and tighten the set screw.
CAUTION: Indicator plate must be installed before sleeve.
7. (b) For e705 & e710
Place sleeve O-ring on the bonnet shoulder. Slide
sleeve over the O-ring until it stops and replace trim
plate and handle.
If you have any problems, comments, or suggestions,
please contact your Powers representative. We are
interested in feedback from the field.
HANDLE TRIM
TEMP.
LIMIT
STOP
BODY
SLEEVE
SLEEVE
"O" RING
CHECKSTOPS
CARTRIDGE
BONNET
Figure 1
IIe700CR 0632 EDP# 6511200
IIe700CR
INSTALLATION INSTRUCTIONS
Cartridge Replacement
T P
© 2006 Powers
USA: Phone: 1.800.669.5430 • Fax 1.847. 229 . 0526 • www.powerscontrols.com
Canada: Phone: 1.888.208.8927 • Fax 1. 888. 882 .1979 • www.powerscontrols.ca
Series e700