RCBS Mini Grand Instruction Manual - Manual (Page 13)

3” and 3 ½” hulls
To load 3” and 3 ½” hulls, no adjustments are necessary at Stations 1, 2 or 3. Seat wads according to the Component
Adjustment section. The Crimp Start (Station 5), Crimp (Station 6) and Taper Crimp (Station 7, if installed) dies need to be
raised up to accommodate the longer hulls. Loosen the Jamb Nut and adjust as necessary.
MAINTENANCE
Lubricate the Main Shaft and pivot points of the Handle with a light machine oil or grease.
Periodic cleaning of the Charge Bar channel is necessary to remove powder and lead residue. It is a good practice to
clean this area prior to each loading session or when changing bushings.
Use a silicone cloth or a light preservative oil on all blued parts to help to prevent rust.