RCBS Hand Priming Tool - Manual (Page 4)

GENERAL INFORMATION
The Hand Priming Tool from RCBS is the safest priming tool you can get your hand on. Its most
important feature is the exclusive safety gate mechanism which isolates the primer seating op-
eration from the primer supply. The gate is an essential safety mechanism and is designed to
eliminate the possibility of a primer tray detonation caused by an improperly seated primer
propogating or “flashing back” into the tray of primers. The gate will cause a small amount of
inconvenience when changing shell holders but it is an essential part of the tool. DO NOT UN-
DER ANY CIRCUMSTANCE attempt to operate the tool without the safety gate in position or
attempt to modify the tool in any way. Primer rods and primer feeds for large and small primers
are provided and are easily interchanged. Other features include:
• A primer feeding system that requires no hand contact with primers.
• A detachable 100-count primer tray that is “grooved” to position primers
anvil-side-up.
• A die cast body designed to fit comfortably in the palm of your hand.
• Uses standard RCBS shell holders manufactured after 1980 - the same ones used on
RCBS presses. This eliminates the cost and hassle of buying extra equipment.
• Covered by our lifetime guarantee.
Unpack the Hand Priming Tool carefully. Look for and identify the following items:
• Hand Priming Tool with large primer feed installed
• Green plastic primer tray with clear plastic lid
• Plastic bag with the following parts: Small Primer Feed, Small and Large
Primer Rods.
Refer to the parts list at the end of these instructions for part numbers and descriptions.
TO USE
The Hand Priming Tool has been assembled and shipped with the large primer feed in position.
The small primer feed can be located in the parts bag. Each primer feed is identified with an “L”
or an “S” for large or small primers. Also, the large and small primer feeds are each a different
color. The large primer feed is black and the small primer feed is white.
Before the Hand Priming Tool can be used, the appropriate shell holder must be installed on top
of the primer feed and the large or small primer rod dropped into the body of the priming tool. To
do this, follow these simple steps:
Grip the priming tool in your hand and gently squeeze the handle. Loosen the safety gate screw
on the handle and pull the safety gate out of the tool. Be sure to keep the handle compressed. If
you release the tension on the handle without the safety gate in position, the tool will open too far
and the internal parts will need to be realigned. This is a safety feature so the tool cannot be used
without the safety gate in place.
Now slide the primer feed to the side and out of the tool. Place the appropriate shell holder on top
of the primer feed and slide the unit back into the priming tool body. See Photo #1. Replace the