RCBS Powder Trickler 2 - Manual (Page 2)

Photo 3 Insert tube and install retaining ring
(UPGRADE KIT assembly starts here)
Slide the Powder Dispensing Tube extension over the Powder
Tube and secure the Socket Head Set Screw.
Photo 4 Secure extension tube set screw
Place the Powder Trickler onto the Adjustable base, align the
Powder Dispensing tube with the “SCALE” marking on the upper
portion of the Adjustable base. Alignment of the dispensing tube
with the “SCALE” mark adds a slight draft(taper) to speed the
trickling process. Secure the three socket head set screws in the
upper base.
Photo 5 Align dispensing tube with “SCALE” mark on upper base
Photo 6 SECURING the three SHSS
USE
Unscrew the lower portion of the Adjustable Base until the
desired powder dispensing tube height is achieved. The
dispensing tube should be ¼” or greater above the scale pan.
Fill the Powder Trickler reservoir with smokeless powder and
turn the dispensing tube clockwise to start the flow of powder.
At the end of the reloading session, pour the remaining
smokeless powder back into the original factory container. This
will preserve the identity and shelf life of the smokeless powder.
MAINTENANCE
Periodically clean powder trickler tubes and body. Use alcohol or
Outers Crud Cutter to remove oils or solvents.
Clean Powder Trickler when changing powders to prevent
contamination. Pay special attention to the interior of the powder
trickler tube and insure that there is no powder from the previous
session stuck inside the tube.
Customer Service
1-800-533-5000 (US or Canada) or 530-533-5191
Hours: Monday - Thursday, 6:30am - 4:00pm Pacific Time
(hours may vary)
e-mail: [email protected] or visit our website at www.rcbs.com
RCBS 605 Oro Dam Blvd. East Oroville, CA 95965
7200561/1010