RCBS Quick Change High Capacity Powder Measure - Manual (Page 4)

4
• DO NOT store primers in bulk. The blast of just a few hundred primers is
sufficient to cause serious injury to anyone nearby.
• DO NOT force primers. Use care in handling primers.
• DO NOT have more than one can of powder on the bench at one time. Powder
cans should be stored away from the bench to avoid picking up the wrong one.
• DO NOT use any powder unless its identity is positively known. The only
positive identification is the manufacturer's label on the original canister.
Discard all mixed powders and those of uncertain identity.
• DO NOT attempt to prime military cartridge cases with crimped/staked primer
pockets until the crimp/staking has been removed with a reamer or by swaging.
Attempting to seat primers into staked/crimped primer pockets can result in
primer detonation, which can cause serious personal injury.
• DO NOT decap live primers. This is extremely dangerous and can result in
primer detonation causing serious personal injury.
• If you use a powder measure, replace the lids on both the powder hopper and
powder can after the powder hopper has been filled.
• When using a powder measure, settle the powder in the powder hopper before
charging any cases. Throw and check the weight of at least ten charges. This
will assure you that the correct powder charge is being thrown.
• When you finish a reloading session, pour any remaining powder back into its
original factory container. This will preserve the identity and shelf life of the
powder.
• DO NOT smoke while reloading.
RECORD KEEPING
• Keep complete records of reloads. Apply a descriptive label to each box
showing the date produced, and the primer, powder and bullet used. Labels for
this purpose are packed with SPEER bullets.
• Never attempt to guess at the identity of your ammunition.
Because RCBS has no control over the choice of components, the manner in
which they are assembled, the use of this product, or the firearms in which the
resulting ammunition may be used, we assume no responsibility, expressed or
implied, for the use of ammunition reloaded with this product.
WARNING: NOT FOR USE WITH BLACK POWDER!
GENERAL INFORMATION
The Quick Change High Capacity Powder Measure will perform two powder
charging tasks in one fast, simple operation. With cycling of the handle it
accurately measures powder within a fraction of a grain and swiftly dispenses it
into cases, one after another. Powder pours uniformly from the powder hopper
into the measuring cylinder, through the drop tube and into the case. This
eliminates the hazards of overloads caused by clogging when charges are
dumped into cases. You can change from one charge to another quickly and
9
Key# Description
Part # Qty
1
QC PM Lock Pin Retainer 7798847 1
2 QC PM Lock Pin 7798846 1
3 QC PM Lock Knob 7798848 1
4 Century Spring 7109029 1